Vláknový transceiver BlueOptics JW092A 10000 Mbit/s SFP+ 1310 nm

The BlueOptics JW092A is a fiber optic SFP+ transceiver module designed for 10 Gbit/s links at a transmission wavelength of 1310 nm. It fits SFP+ slots and provides a compact solution for extending optical connections in switches, routers and transceivers that support standard SFP+ modules. The module is intended for single-lambda operation on multimode or single-mode fiber distances appropriate to 1310 nm systems and offers a plug-and-play form factor for straightforward integration into existing network hardware.

Advantages

The transceiver supports a maximum data transfer rate of 10000 Mbit/s and conforms to the SFP+ form factor, enabling high-density port deployments and reduced rack space usage. Operating at 1310 nm ensures compatibility with common optical links and network equipment designed for mid-range fiber distances. The compact SFP+ design simplifies hot-swapping and replacement without powering down connected devices, which helps maintain network uptime during maintenance.

Suitable for

• 10 Gbit/s uplinks between switches and routers
• Server-to-switch connections in data centers
• Metro and enterprise fiber links operating at 1310 nm
• Equipment requiring SFP+ form-factor transceivers for optical connectivity

Key specifications

• Interface type: SFP+
• Maximum data transfer rate: 10000 Mbit/s (10 Gbit/s)
• Operating wavelength: 1310 nm
• Form factor: compact SFP+ optical transceiver
• Hot-pluggable module suitable for high-density ports

How to use

Install the BlueOptics JW092A into an available SFP+ port on compatible networking equipment until it clicks into place. Connect the appropriate fiber patch cable matching the transceiver's connector type and fiber specification. Configure the connected devices as required for 10 Gbit/s operation and verify link status through the switch or router management interface. Replace the module by gently removing it while the host device supports hot-swap, or follow the equipment vendor's guidance for safe removal when necessary.

Recommendations

Use fiber cabling and connectors rated for 1310 nm operation and verify that cable type and length meet your network design requirements. Check equipment compatibility with SFP+ modules and validate link parameters after installation to ensure correct speed and modulation settings. Handle the transceiver by its housing, avoid touching the optical interfaces, and keep protective caps in place when the module is not connected to prevent contamination.