XFP transceiver modul BlueOptics 943 919-001-BO 1310 nm LC 10000 m

The BlueOptics 943 919-001-BO XFP transceiver module is designed for high-speed single‑mode fiber links operating at a wavelength of 1310 nm. It implements an XFP interface with an LC duplex optical connector, supports optical transmission distances up to 10,000 m, and targets 10 Gigabit Ethernet and similar high‑speed network protocols. The module is compact and lightweight (approximately 20 g) and is intended for integration into compatible networking equipment that accepts XFP pluggable transceivers.

Advantages

This XFP transceiver provides a standardized MSA‑compliant form factor for easy interchangeability and broad hardware compatibility. Operating at 1310 nm over single‑mode fiber, it enables long‑reach connections up to 10 km while maintaining low power consumption and a small physical footprint. The LC duplex connector allows simultaneous transmit and receive channels on two fibers. The module's lightweight, grey housing and XFP electrical/mechanical interface make it suitable for many switch, router and storage hardware platforms that support XFP.

Suitable for (tasks / use cases)

• 10 Gigabit Ethernet links over single‑mode fiber
• Long‑reach connections up to 10 km between network equipment
• Interconnects for switches, routers and storage systems with XFP ports
• Replacement or expansion of existing XFP-based fiber links

Key specifications

• Interface type: XFP
• Wavelength: 1310 nm
• Maximum transmission distance: 10,000 m (10 km) over single‑mode fiber
• Connector: LC duplex
• Typical weight: 0.02 kg
• Product colour: Grey

How to use

Install the transceiver into an XFP slot on compatible network equipment following the device manufacturer’s hot‑plug or installation instructions. Connect LC duplex single‑mode fiber patch cords to the transceiver’s LC ports, ensuring correct transmit/receive alignment. Configure the host device for the intended protocol (for example 10GBASE‑LR) and verify link status through the equipment management interface. Observe standard ESD precautions when handling the module and keep optical connectors covered when not in use to prevent contamination.

Recommendations

Use single‑mode fiber and high-quality LC patch cords for optimal reach and signal integrity. Confirm that the host hardware supports XFP transceivers and the chosen transmission protocol, and enable any digital diagnostic monitoring features provided by the host to monitor supply voltage, optical power and temperature where supported.