Aktívny optický kábel BlueOptics QSFP28 100GBASE-SR4 Ethernet, 5 m (980-9I13X-00C005-BO)

The Active Optical Cable BlueOptics QSFP28 100GBASE-SR4 Ethernet, 5 m is a factory-terminated duplex optical link intended for short-reach 100 Gbps multimode connections. Designed for direct attachment to QSFP28 ports, this AOC provides a single, pre-assembled cable solution that eliminates separate transceivers and fiber patch cords. The 5 meter length and multimode design make it suitable for typical data centre top-of-rack and adjacent-rack interconnects, supporting high-bandwidth traffic between switches, routers and servers while reducing cable management complexity.

Advantages

The cable integrates transceiver optics and fibre into one pre-tested assembly, ensuring consistent signal performance and simplified deployment. Its multimode 100GBASE-SR4 operation supports high throughput with low latency over short distances and reduces power and space compared with separate module-plus-patch-cord setups. The AOC design offers predictable electrical and optical parameters, lower insertion effort and fewer components to manage in dense networking environments.

Suitable for

Key specifications

How to use

Install the AOC by plugging each QSFP28 connector into matching QSFP28 ports on the equipment to be connected. Ensure both devices are powered and configured to support 100GBASE-SR4 operation. Handle the cable by its connectors and avoid sharp bends along the fibre region; observe equipment manufacturer guidelines for port insertion and removal. No separate transceivers or patch cords are required, which simplifies setup and reduces installation steps.

Recommendations

Use the cable within the supported 5 m distance for multimode short-reach applications and avoid routing through areas with excessive mechanical stress or tight bend radii. Verify that connected devices support QSFP28 and the 100GBASE-SR4 standard; consult device compatibility lists where necessary to ensure proper link training and full 100 Gbps operation.