AOC SFP28 BlueOptics BO272703Q2M aktívny optický kábel 2 m, CBO SFP28-AOC-2M-MV-BO

The AOC SFP28 BlueOptics BO272703Q2M Active Optical Cable is a 2 meter direct-attach solution designed for SFP28 ports, delivering a reliable 25GbE optical link between compatible switches, servers and network appliances. This cable integrates optical transceivers and a multimode fiber assembly into a single pre-terminated unit, eliminating the need for separate transceivers and patch cords while reducing insertion loss and simplifying rack-level cabling for short-reach data center connections.

Advantages

This active optical cable provides native support for 25 Gigabit Ethernet over a compact SFP28 form factor, offering low power consumption and consistent signal integrity across the 2 m reach. By combining transceiver functionality and the fiber medium in one factory-tested assembly, it reduces inventory complexity and the chance of compatibility or connector-mating errors. The multimode optical path minimizes attenuation for short distances and helps maintain latency and throughput required for server-to-switch and switch-to-switch links.

Suitable for

• Interconnections between servers and Top-of-Rack or Leaf switches supporting SFP28 25GbE ports
• High-density data center cabling where simplified deployment and low insertion loss are required
• Switch-to-switch uplinks or stack connections within the same rack or adjacent racks
• Network environments seeking a pre-terminated, low-maintenance short-reach optical link

Key specifications

• Interface: SFP28 connectors (plug-and-play into SFP28 ports)
• Data rate: 25 Gigabit Ethernet
• Length: 2 meters
• Cable type: Active Optical Cable with multimode optical fiber
• Power: low-power SFP28 active module design
• Typical use: short-reach data center and enterprise interconnects

How to use

Install the AOC by inserting each SFP28 connector into the corresponding SFP28 port on target devices until the module latches. Ensure both devices support SFP28 and 25GbE operation and verify link status via device LEDs or management interfaces. No separate transceivers or patch cords are required; the pre-terminated cable carries the optical link internally. For removal, press the latch mechanism on the connector and gently pull straight out to avoid damaging the port.

Recommendations

Use the cable for short-reach connections within racks or between adjacent racks. Avoid sharp bends with radii below the manufacturer’s minimum for multimode fiber, and route the cable to minimize mechanical stress and excessive pulling forces. Confirm firmware and hardware compatibility of network equipment before deployment to ensure proper link negotiation and performance.