CBO transceiver SFP-10G-BX-D 10G single-mode 1310nm

The CBO Transceiver SFP-10G-BX-D 10G Single-Mode 1310nm is a 10 Gigabit SFP+ fiber optic module intended for single-mode fiber links at 1310 nm wavelength. It provides a compact SFP+ form factor for integration into compatible switches, routers and network appliances, supporting high-speed uplinks and point-to-point connections in environments such as data centers and carrier networks. The module is designed for use where reliable 10G connectivity and low physical footprint are required.

Advantages

This single-mode 10G transceiver supports standard SFP+ interfaces and is compatible with equipment that accepts industry-standard optical modules, enabling flexible deployment for uplink or long-reach connections. The 1310 nm wavelength and single-mode design facilitate lower attenuation over longer distances compared with multimode alternatives, while the compact SFP+ size conserves module slots in networking hardware. The module is intended to provide stable performance for 10 Gigabit Ethernet links with straightforward installation and hot-pluggable operation.

Suitable for

• 10 Gigabit Ethernet uplinks between switches and aggregation points
• Point-to-point fibre links in data centers
• Carrier and metropolitan area network interconnects
• Network equipment with SFP+ ports requiring single-mode 1310 nm optics

Key specifications

• Form factor: SFP+ (small form-factor pluggable, 10G capable)
• Wavelength: 1310 nm for single-mode fiber transmission
• Data rate: 10 Gigabit Ethernet support
• Optical reach: suitable for single-mode links (distance depends on fiber type and link budget)
• Interface: LC optical connector
• Hot-pluggable SFP+ module
• Power consumption: low-profile SFP+ class module

How to use

Install the transceiver by inserting the SFP+ module into a compatible SFP+ port on the network device until it clicks into place. Connect single-mode fiber cables with LC connectors to the transmit and receive ports, ensuring correct polarity. Configure the network device port for 10 Gigabit operation as required by your switch or router; the module typically operates as a plug-and-play optic but may require interface settings or firmware compatibility checks on some equipment. To remove, power down the port if recommended by the device manufacturer, then depress the module latch and pull the module straight out.

Recommendations

Verify device compatibility and firmware support for third-party SFP+ modules before deployment. Use appropriate single-mode fiber (SMF) and proper attenuation calculations for the intended link distance. Handle the optical connectors carefully, keep dust caps on when not in use, and follow electrostatic discharge (ESD) precautions during installation and removal to maintain reliable optical performance.