BlueOptics JNP-100G-AOC-10M-BO InfiniBand/optický kábel QSFP28 aqua 10 m konektor samec/konektor samec

The BlueOptics JNP-100G-AOC-10M-BO InfiniBand/fibre optic cable QSFP28 Aqua 10m Male/Male is a 10 metre active optical cable (AOC) with QSFP28 connectors designed for 100GBASE-SR4 applications. The cable integrates transmitter and receiver modules on each end and uses multimode optical fibre to provide high-bandwidth, low-latency connectivity between switches, routers and storage systems. The pre-assembled QSFP28-to-QSFP28 design simplifies installation in data centre and networking environments and removes the need for patch cords or separate transceivers.

Advantages

This 10 m BlueOptics AOC follows MSA-compliant QSFP28 specifications for 100G data rates and supports Ethernet, Fibre Channel over Ethernet and SDH/SONET protocols up to 100 Gbit/s. As an active optical cable it reduces electromagnetic interference and enables reliable optical transmission with minimal signal loss over the specified distance. The cable includes digital diagnostic monitoring (DDM/DOM) functionality to report parameters such as supply voltage, laser bias current, transmit power, receive power and temperature for remote troubleshooting and maintenance.

Suitable for

• High-density data centre interconnects between QSFP28 ports
• Aggregation links in campus and enterprise networks
• High-performance computing and InfiniBand-like deployments requiring 100G links
• Switch-to-switch, switch-to-router and switch-to-storage connections

Key specifications

• Connector type: QSFP28 to QSFP28 (male/male)
• Length: 10 metres
• Data rate: up to 100 Gbit/s (100GBASE-SR4 compatible)
• Medium: multimode optical fibre (active optical cable)
• Compatibility: MSA-compliant QSFP28 form factor for equipment supporting 100G AOC
• Diagnostic: Digital Diagnostic Monitoring (DDM/DOM) per SFF-8472
• Color: Aqua jacket

How to use

Install the BlueOptics QSFP28 AOC by inserting each QSFP28 plug into the corresponding port until the connector latches. Ensure the host devices support 100G AOC modules and, if required, enable or verify DDM/DOM support in the device management interface to read diagnostic values. No additional transceivers or fibre patching is required; route the pre-assembled cable to avoid tight bends and mechanical stress. Power on both connected devices and verify link status and speed through the equipment's interface.

Recommendations

Avoid sharp bends and excessive pulling force on the cable; maintain the manufacturer’s minimum bend radius and keep connectors free of dust. Verify that the network equipment firmware or software supports the use of third-party AOCs where applicable and enable DDM/DOM monitoring to assist with diagnostics and maintenance.