Optický transceiver CBO SFP-10G-LRM 10G 1310nm

CBO SFP-10G-LRM 10G 1310nm is a fiber optic SFP+ transceiver module by BlueOptics engineered for short-reach multimode fiber connections. The module supports 10 Gigabit Ethernet operation at a 1310 nm wavelength and fits the compact SFP+ form factor, enabling hot-pluggable installation into compatible switches, routers and servers. Designed for reliable data transfer over multimode fiber links, it simplifies port upgrades and network expansions while maintaining standard 10G performance.

Advantages

The module delivers 10G data rates over multimode fiber using the 1310 nm optical window, combining a small SFP+ footprint with hot-pluggable capability for minimal service interruption during installation or replacement. Its design supports interoperability with industry-standard SFP+ ports and reduces cabling complexity for short-reach deployments, enabling straightforward upgrades from lower-speed interfaces to 10 Gigabit connectivity.

Suitable for

• 10 Gigabit Ethernet links over multimode fiber in data centers and enterprise networks
• Upgrading switch or server ports to 10G capacity without replacing chassis
• Short-reach backbone connections and aggregation links within campus or building environments
• Interoperable connections between switches, routers and blade servers with SFP+ slots

Key specifications

• Form factor: SFP+ (hot-pluggable)
• Data rate: 10 Gbps
• Wavelength: 1310 nm
• Fiber type: Multimode fiber (MMF) for short-reach links
• Typical reach: designed for short-reach multimode connections (LRM class)
• Protocol: 10 Gigabit Ethernet compatible
• Operating environment: designed for standard telecommunications equipment operating conditions

How to use

Install the transceiver by inserting the SFP+ module into a compatible SFP+ port on a switch, router or server until it clicks into place. Connect the multimode fiber patch cable with LC connectors to the transceiver’s optical interface, ensuring correct fiber polarity and secure connections. After physical installation, verify link status and speed via the host device management interface and monitor optical diagnostics if available. To remove the module, follow the device manufacturer’s hot-swap or shutdown recommendations and extract the transceiver by depressing the latch and pulling it straight out.

Recommendations

Use quality multimode fiber and LC patch cords rated for 10G performance, maintain clean connector endfaces, and confirm compatibility with the host equipment’s SFP+ slot and firmware. Avoid extended distances beyond the specified short-reach range and follow industry-standard handling procedures for electrostatic discharge and optical safety.