BlueOptics QSFP-H40G-AOC2M-BO InfiniBand optický kábel 2 m oranžový

The BlueOptics QSFP-H40G-AOC2M-BO InfiniBand fibre optic cable 2 m Orange is a 2-metre active optical cable (AOC) with QSFP-to-QSFP male connectors designed for high-speed links in data centers and networking environments. It implements QSFP form-factor connectivity and supports multimode fibre transmission with integrated transmitter and receiver modules in each connector. The cable is intended for short-reach, low-latency connections between servers, switches and storage devices where 40 Gbit/s class links are required.

Advantages

This active optical cable offers a compact QSFP-to-QSFP connection that simplifies cabling between compatible ports and reduces electrical-to-optical conversion complexity by integrating transceivers in the cable ends. Its 2 metre length provides flexible rack- and cabinet-level routing while maintaining low latency and stable signal integrity over multimode fibre. The orange outer jacket follows common colour conventions for multimode links, aiding identification in dense cabling environments.

Suitable for

• Short-range 40 Gbit/s links between QSFP ports in switches and routers
• Server-to-switch connections within racks or between adjacent cabinets
• High-performance computing clusters and InfiniBand fabrics requiring low latency
• Storage networking and Fibre Channel over Ethernet links up to 40G

Key specifications

• Connector type: QSFP male to QSFP male
• Cable type: Active Optical Cable (AOC) with multimode fibre
• Rated data rate: up to 40 Gbit/s aggregate
• Length: 2.0 metres
• Colour: orange outer jacket
• Form factor: QSFP (Quad Small Form-factor Pluggable)

How to use

Install the BlueOptics QSFP-H40G-AOC2M-BO by inserting each QSFP connector into the corresponding QSFP port on your network device until it seats securely. Ensure ports on both devices are powered and configured for compatible 40 Gbit/s modes (for example 40GBASE-SR4 or an equivalent InfiniBand profile) before enabling traffic. Route the 2 m cable to avoid sharp bends and mechanical strain on the connectors; maintain manufacturer-recommended bend radius for multimode fibre. No separate external transceivers or patch cords are required with this AOC.

Recommendations

Verify compatibility with your hardware platform and firmware versions before deployment, and test links after installation to confirm correct speed and link health. Use the cable for short-reach connections inside racks or between adjacent cabinets and avoid extended outdoor runs or environments with extreme temperatures or mechanical stress.