SFP 1G optický transceiver CBO SFP-1G-LH pre 1 Gbit/s singlemode pripojenia na dlhé vzdialenosti

The BlueOptics SFP 1G Fiber Optic Transceiver CBO SFP-1G-LH is a compact, hot-pluggable module engineered for 1 Gbps single‑mode long‑haul links. Designed to fit standard SFP ports on switches, routers and media converters, this transceiver converts electrical signals to optical signals for reliable optical uplinks and backbone connections. The module supports extended reach over single‑mode fiber, making it suitable for data center interconnects, enterprise network aggregation and telecom long‑distance links where stable, low-latency optical transmission is required.

Advantages

The transceiver provides a small form-factor footprint and hot-swap capability, allowing installation or replacement without powering down equipment. It supports single‑mode operation for long-reach transmission and is compatible with common SFP-enabled networking hardware, enabling straightforward integration into existing optical infrastructures. The device offers consistent 1 Gbps throughput and optical link stability, reducing the need for additional converters or adapters in long-haul deployments.

Suitable for

• Data center uplinks and inter-rack connections over single‑mode fiber
• Enterprise backbone links between buildings or floors
• Telecom access and metro links requiring long reach
• Network switches, routers and media converters with SFP slots

Key specifications

• Interface: SFP (small form-factor pluggable) module for 1 Gbps operation
• Optical mode: Single‑mode fiber support for long-distance transmission
• Data rate: 1 Gbps full‑duplex
• Form factor: Hot-pluggable SFP compact transceiver
• Wavelength: Designed for long‑haul optical links (single‑mode wavelength typical for long reach)

How to use

Insert the transceiver into a compatible SFP slot on your switch, router or media converter until it latches. Connect single‑mode fiber patch cords to the transceiver’s optical port using appropriate LC connectors and ensure correct fiber polarity. After physical connection, verify link status and configuration in the networking equipment’s interface settings; the module is hot‑swappable and should be detected automatically by most SFP‑capable devices. Follow standard fiber handling practices to avoid contamination of fiber endfaces.

Recommendations

Store and handle the transceiver in a clean, dry environment and use dust caps when ports are not connected. Verify compatibility with the host device and consult fiber link budget calculations to confirm expected reach. Clean fiber connectors before mating and avoid bending fiber beyond minimum bend radius for reliable long‑haul performance.