SFP+ Transceiver CBO SFP-10G-ER-1310 10Gbps 1310nm

CBO SFP-10G-ER-1310 is an SFP+ optical transceiver that supports a 10Gbps data rate at a 1310nm wavelength. Designed for long-reach single-mode fiber links, this BlueOptics module enables 10G connectivity in network switches and routers that accept SFP+ form-factor modules. It is suitable for deployment in data center uplinks, enterprise backbone connections and metro networks where stable 10G transmission and extended reach are required.

Advantages

The transceiver provides stable 10Gbps performance over single-mode fiber at 1310nm, offering extended reach for long-distance links. Its SFP+ form factor ensures compatibility with a wide range of network switches and routers that support hot-pluggable modules. The module is engineered for consistent optical performance, low power consumption and straightforward integration into existing fiber infrastructure.

Suitable for

• Data center uplinks between aggregation and core switches
• Enterprise backbone and campus interconnects
• Metro and carrier Ethernet links requiring long-reach 10G
• Upgrading legacy equipment to 10G over single-mode fiber

Key specifications

• Data rate: 10 Gbps
• Optical wavelength: 1310 nm
• Form factor: SFP+
• Fiber type: Single-mode fiber (SMF)
• Connector: LC duplex
• Transmission: Long-reach 10G
• Hot-pluggable: Yes

How to use

Insert the SFP+ transceiver into an SFP+ port of a compatible switch or router while the device is powered on or off, following the equipment manufacturer's guidance for hot-plugging. Connect LC duplex single-mode fiber cables to the module, ensuring correct transmit/receive orientation. Verify link status via the networking device's management interface and monitor optical parameters if supported. Use appropriate fiber patching and labeling practices to maintain link integrity.

Recommendations

For reliable long-reach performance, use single-mode fiber with proper attenuation and connector cleanliness. Check device compatibility lists for SFP+ modules where possible and confirm transceiver settings such as speed and duplex in the host device. Avoid bending fibers beyond recommended radii and maintain clean LC connectors to prevent performance degradation.