Optický transceiver modul BlueOptics CPAC-TR-40SR-QSFP-BIDI-BO 40000 Mbit/s

The BlueOptics CPAC-TR-40SR-QSFP-BIDI-BO 40000 Mbit/s is a fiber optic transceiver module designed for high-density network environments requiring a QSFP form factor and up to 40 Gbit/s throughput. This silver-colored, lightweight module weighs approximately 40 g and delivers duplex bidirectional optical connectivity in a compact QSFP package. With a mean time between failures (MTBF) of 1,000,000 hours, it is intended for integration into switches, routers and other networking equipment that accept QSFP-compatible transceivers.

Advantages

The module provides a high data transfer rate of 40000 Mbit/s in a single QSFP transceiver, enabling consolidation of higher bandwidth links in limited rack space. Its compact QSFP form factor supports dense port configurations and simplifies replacement or upgrades in systems designed for modular transceivers. The low weight and standardized QSFP interface make handling and installation straightforward while the high MTBF indicates robust operational reliability for continuous network use.

Suitable for

• 40 Gbit/s uplinks between switches and aggregation devices
• High-density data center top-of-rack and spine deployments
• Fiber runs requiring QSFP bidirectional optical modules
• Environments where compact, hot-swappable transceivers are required

Key specifications

• Interface type: QSFP
• Maximum data transfer rate: 40000 Mbit/s
• Form factor: QSFP
• Product colour: Silver
• Weight: 0.04 kg
• Mean time between failures (MTBF): 1,000,000 hours

How to use

Install the BlueOptics QSFP transceiver into a compatible QSFP port on your networking device following the device manufacturer's hot-swap procedure if available. Ensure the module is fully seated and locked, then connect the appropriate single-fiber bidirectional optical cables or patch cords that match the module's optical specifications. Verify link status and configure interface settings on your switch or router to enable the desired 40 Gbit/s operation. For initial deployment, perform link tests and monitor signal metrics to confirm stable operation.