SFP transceiver modul BlueOptics 722093 1250 Mbit/s 850 nm

The BlueOptics 722093 SFP transceiver module is a compact fiber optic interface designed for single‑slot SFP ports. With a maximum data transfer rate of 1250 Mbit/s and an operating wavelength of 850 nm, this module supports short‑range multimode fiber links and standard SFP hot‑swap compatibility. It provides a straightforward way to add optical connectivity to switches, routers and media converters that accept SFP modules.

Advantages

The module offers a standardized SFP form factor for easy installation and replacement without powering down equipment. Operating at 850 nm and rated for 1250 Mbit/s, it supports reliable short‑reach data transmission over multimode fiber. Its compact design and industry‑compatible electrical and optical interface make it suitable for mixed vendor environments and typical enterprise networking racks.

Suitable for

• Short‑range multimode fiber links in campus and data center networks
• Connecting switches, routers and media converters with SFP ports
• Upgrading copper ports to optical links for reduced electromagnetic interference
• Redundant fiber connections and link aggregation in network topologies

Key specifications

• Form factor: SFP (small form‑factor pluggable)
• Maximum data transfer rate: 1250 Mbit/s
• Optical wavelength: 850 nm
• Fiber type: multimode fiber (MMF) suitable for short‑reach links
• Hot‑pluggable design
• Typical connector: LC duplex (industry standard for SFP optics)

How to use

Insert the BlueOptics SFP transceiver into an empty SFP port on a switch, router or media converter until it clicks into place. Connect a compatible multimode fiber patch cable to the module’s optical connector, observing correct transmit/receive orientation. After installation, verify link status and speed through the host device management interface and confirm that the module is recognized and operating at the expected 1250 Mbit/s rate.

Recommendations

Use multimode fiber patch cables matched to the module’s 850 nm wavelength and keep connectors clean to ensure optimal signal quality. Install and remove the module with the host device powered according to the equipment manual if hot‑swap is not supported by the specific hardware. For longer distances or single‑mode fiber deployments, select an appropriate transceiver with suitable wavelength and reach.