Transceiver modul s optickým vláknom BlueOptics 3FE65831AA 10000 Mbit/s SFP+ 1550 nm

The BlueOptics 3FE65831AA 10000 Mbit/s SFP+ 1550 nm fiber optic transceiver module is a compact networking component designed for high-speed optical links. It supports data transmission up to 10 Gbit/s over single-mode fiber at a wavelength of 1550 nm, making it suitable for long-reach and metro network segments. The module fits SFP+ slots and provides a standardized optical interface for switches, routers and media converters compatible with SFP+ form factor.

Advantages

This transceiver delivers a reliable 10 Gbit/s optical connection with industry-standard SFP+ compatibility, enabling straightforward integration into existing network hardware. Operating at 1550 nm optimizes the module for longer transmission distances and lower attenuation on single-mode fiber. The compact SFP+ form factor reduces space requirements in network equipment and simplifies upgrade paths from lower-speed modules.

Suitable for

• Long-reach single-mode fiber links in metro and carrier networks
• 10 Gigabit uplinks between switches and routers
• Data center spine and aggregation connections requiring SFP+ ports
• Optical links for ISPs and enterprise WAN circuits

Key specifications

• Form factor: SFP+
• Nominal data rate: 10000 Mbit/s (10 Gbit/s)
• Wavelength: 1550 nm
• Fiber type: single-mode fiber (SMF)
• Application: long-reach optical transmission

How to use

Install the module into an SFP+ port on compatible network equipment following manufacturer instructions for hot-pluggable optics. Connect a single-mode fiber patch cable with matching connectors to the transceiver optical port, observing correct transmit/receive orientation. After physical installation, verify link status through the device management interface and configure network settings such as duplex and speed where applicable. Monitor signal and link diagnostics if supported by host equipment.

Recommendations

Use certified single-mode fiber and quality patch cords rated for 1550 nm to ensure optimal performance. Avoid exposing the optical interface to dust and always use protective caps when the transceiver is not connected. Confirm compatibility with the host device's SFP+ port and check for required firmware settings before deployment.