Aktívny optický kábel (AOC) CBO SFP-AOC-10G-20M 10 Gbit/s SFP+ 20 m LC

CBO SFP-AOC-10G-20M 10 Gbps SFP+ 20 m LC is a 20-metre Active Optical Cable (AOC) with SFP+ interfaces and LC connector terminations designed for 10 Gigabit Ethernet links. The integrated design combines SFP+ transceivers with multimode optical fiber in a single, factory-terminated assembly to provide a compact, low-power alternative to separate transceivers and patch cables. The cable supports high-throughput, low-latency connections between servers, switches and storage devices in rack and data centre environments while offering immunity to electromagnetic interference.

Advantages

The AOC provides a single-cable solution that removes the need for separate transceivers and field-terminated fiber, reducing installation time and potential points of failure. At 10 Gbps and 20 metres length, it is suitable for short-reach interconnects inside racks or between adjacent racks, offering low power consumption and negligible signal loss compared with copper alternatives. Integrated SFP+ modules ensure hot-pluggable compatibility with standard SFP+ ports and help maintain predictable optical performance across deployments.

Suitable for

• 10 Gigabit server-to-switch connections within racks
• Switch-to-switch links in data centre or campus backbone
• Storage area network (SAN) interconnects and aggregation
• High-density top-of-rack (ToR) deployments with short reach requirements

Key specifications

• Connector type: SFP+ interfaces with LC optical terminations
• Data rate: 10 Gbps (10 Gigabit Ethernet compatible)
• Length: 20 metres
• Optical medium: integrated multimode fiber within active cable assembly
• Latency: low propagation delay suitable for low-latency networks
• EMI performance: immune to electromagnetic interference typical of optical links
• Power consumption: lower than separate transceiver + copper solutions (typical for AOC design)

How to use

Install the cable by inserting each SFP+ connector into compatible SFP+ ports on network devices until the latch engages. Confirm that devices support active optical cable modules and verify link status through device LEDs or management interfaces. No field termination or optical cleaning of exposed fiber is required, but ensure LC connector end faces are free of dust before insertion. For hot-swap operations, follow the host device vendor guidance regarding safe insertion and removal to avoid transient link errors.

Recommendations

Use this AOC for reliable short-reach 10GbE links in rack and data centre environments. Avoid tight bends and excessive pulling during routing; maintain the manufacturer’s recommended bend radius. Store unused connectors with protective caps when not connected to prevent contamination.