AOC SFP+ Active Optical kábel CBO 10G 15m pre IBM (SFP-AOC-10G-15M)

The AOC SFP+ Active Optical Cable CBO 10G 15m for IBM provides a direct 10 Gbps optical link over a 15-metre cable, designed to connect SFP+ ports on switches, servers and storage devices. As an active optical cable, it integrates optical transceivers into a unified assembly, eliminating the need for separate SFP+ modules and copper patch cords. The cable is intended for short-reach, high-speed interconnects in data center and enterprise network environments where signal integrity and reduced electromagnetic interference are important.

Advantages

This Active Optical Cable offers a 10 Gbps data rate across a 15 m single assembly, combining low latency and consistent throughput with the physical flexibility of lightweight fiber. Built for compatibility with IBM SFP+ ports, the cable simplifies rack cabling by removing separate transceivers and reduces electromagnetic interference compared with copper interconnects. The integrated design also eases installation and replacement in high-density networking setups.

Suitable for

• 10 Gigabit short-reach uplinks between switches in data centers
• Server-to-switch interconnects within server racks
• High-density network aggregation and top-of-rack connections
• Storage area network (SAN) links requiring reliable 10 Gbps connectivity

Key specifications

• Data rate: 10 Gbps
• Cable type: Active Optical Cable (AOC)
• Length: 15 metres
• Connector form factor: SFP+ on both ends
• Reach: short-reach multimode optical link suitable for intra-rack and inter-rack connections
• Transmission medium: optical fiber with active transceiver electronics integrated in the assembly

How to use

Insert each SFP+ connector into the corresponding SFP+ port on your compatible IBM switch, server or storage device until the connector latches. Ensure both devices are powered and configured to use a 10 Gbps SFP+ link; the connected interfaces should be enabled and set for the appropriate speed and duplex settings or left to auto-negotiate if supported. No separate transceivers or fiber patch panels are required. For removal, depress the latch and gently withdraw the connector to avoid stress on the cable and ports.

Recommendations

Route the cable without sharp bends and maintain the manufacturer’s minimum bend radius. Avoid compressing or tightly tying the cable near the connectors. Use proper port and system compatibility checks when connecting to IBM equipment and verify link status in device management interfaces after installation. For reliable performance in dense rack environments, label both ends of the cable and secure it with non-abrasive fasteners to prevent strain.