Optický 10G transceiver CBO SFP-10G-ER (jednovidový, dlhá vzdialenosť)

CBO SFP-10G-ER is a fiber optic 10G transceiver designed for long-reach single‑mode links. The module supports 10 Gigabit Ethernet over single‑mode fiber and is intended for use in network uplinks, data center connections and telecom equipment where reliable high‑speed transmission and compact SFP form factor are required. Its long‑reach capability makes it suitable for extended distance links while maintaining compatibility with standard SFP cages and common networking hardware.

Advantages

The transceiver provides 10G data rates with single‑mode long‑reach performance, enabling high‑capacity links between switches, routers and optical transport equipment. Its compact SFP form factor simplifies slot utilization and hot‑swap maintenance without powering down systems. The module is built to meet industry optical and electrical interfaces, offering predictable link behavior and interoperability with compliant devices.

Suitable for

• Long‑distance 10 Gigabit Ethernet uplinks between buildings or data centers
• Interconnection of aggregation switches and optical distribution frames
• Telecom and carrier access links requiring single‑mode fiber
• High‑speed backbone links in campus and metropolitan networks

Key specifications

• Transmission rate: 10 Gigabit Ethernet
• Fiber type: single‑mode fiber
• Reach: long‑reach optical transmission suitable for extended distances
• Form factor: SFP (small form‑factor pluggable)
• Interface: duplex optical connector (LC compatible)
• Optical wavelength: standardized long‑reach wavelength for 10G single‑mode links
• Power and thermal: designed for typical SFP power envelopes and operating temperature ranges for rack equipment

How to use

Install the transceiver into a compatible SFP slot on a switch, router or optical line card until it locks in place. Connect single‑mode fiber using LC duplex connectors, ensuring correct transmit/receive alignment. Verify link status and speed on the host device and configure interface parameters as required by the network. For hot‑swap scenarios, follow the host equipment vendor’s procedures to avoid transient link issues.

Recommendations

Use certified single‑mode fiber and quality LC patch cords to maintain signal integrity. Check link budget and optical loss across the installed fiber path to confirm the module’s long‑reach capability for your specific distance. Follow the equipment vendor’s compatibility list and maintain clean fiber connectors to ensure stable 10G links.