SFP+ transceiver CBO SFP-10G-ER-1310 10G 1310nm

The SFP+ Transceiver CBO SFP-10G-ER-1310 10G 1310nm is a compact, hot-pluggable optical module designed for 10 Gigabit Ethernet links over single-mode fiber. Operating at a wavelength of 1310 nm, this transceiver supports long-reach fiber connections and is intended for insertion into SFP+ ports on switches, routers and other networking equipment that accept standard SFP+ modules. The module provides a straightforward way to add or replace 10G optical uplinks in data center and enterprise environments without modifying existing hardware.

Advantages

This transceiver delivers 10G performance with a small form factor and hot-swappable convenience, allowing network upgrades with minimal downtime. Its single-mode 1310 nm wavelength offers extended reach for backbone and inter-building links, while the SFP+ interface ensures wide compatibility with devices that support SFP+ optical modules. The module's fixed-wavelength design and industry-standard connector simplify inventory and deployment for stable optical links.

Suitable for

• 10 Gigabit Ethernet uplinks between switches and routers
• Long-reach single-mode fiber connections in data centers
• Inter-building backbone links and campus networks
• Enterprise core switching and aggregation layers

Key specifications

• Data rate: 10 Gbps
• Optical wavelength: 1310 nm (single-mode fiber)
• Form factor: SFP+ (hot-pluggable)
• Interface type: Duplex LC optical connector
• Typical reach: long-reach single-mode fiber links (designed for extended distances)
• Power and signaling: compliant with SFP+ electrical and optical interfaces

How to use

Insert the transceiver into an empty SFP+ port on a compatible switch or router until it clicks into place. Connect a single-mode fiber patch cable with LC duplex connectors to the module, ensuring correct TX/RX orientation. After insertion, verify link status through the host device’s management interface or status LEDs. To remove, disengage the latch and pull the module out gently while the device is powered down only if recommended by the equipment vendor; many systems support hot swapping.

Recommendations

Use single-mode fiber and appropriate LC duplex patch cables rated for long-reach links. Confirm device compatibility with SFP+ 10G modules and check link diagnostics after installation. Protect optical interfaces with dust caps when not connected and avoid bending fiber beyond recommended minimum radii to preserve signal integrity.