XFP transceiver modul BlueOptics UXFP-192/S1-BO 10000 Mbit/s 1310 nm

The BlueOptics UXFP-192/S1-BO is an XFP transceiver module designed for 10 Gbit/s (10000 Mbit/s) data transmission over single-mode fiber at a wavelength of 1310 nm. Housed in a compact silver XFP package and weighing approximately 20 g, the module complies with RoHS requirements and follows MSA-compatible physical interface standards for use in network equipment with XFP slots and LC duplex fiber connections.

Advantages

The module provides standardized XFP connectivity for 10G links and supports long-reach single-mode transmission at 1310 nm. Its compact form factor and RoHS compliance make it suitable for environmentally conscious deployments. Tested for interoperability with common network platforms, the transceiver offers plug-and-play installation in systems that accept XFP modules and provides stable optical performance for Ethernet and other high-speed protocols.

Suitable for

Key specifications

How to use

Install the transceiver into any compatible XFP slot following your equipment manufacturer’s guidelines. Connect an LC duplex single-mode fiber patch cable to the module’s optical port, ensuring correct transmit/receive orientation. Configure the host device for the required link speed and protocol (for example 10G Ethernet). Perform link validation and optical power checks according to your network procedures. If the host supports digital diagnostics (DDM/DOM), enable and monitor the reported parameters for ongoing maintenance.

Recommendations

Use single-mode LC duplex patch cords and appropriate patch panels to achieve optimal range and signal quality. Verify that the target hardware supports XFP modules and the required optical wavelength. For best results, follow the equipment vendor’s guidance on firmware compatibility and, when available, enable digital diagnostics to monitor optical performance and temperature.